We need to configure one to one NAT for two IP address and one PAT for all remaining IP pool.
Can such one-to-one mapping configured in routers ( in ASA it is static (inside,outside).
Inside- IP1 mapped to Pub_IP1 with overload
Inside - IP2 mapped to Pub_IP2 with overload.
And rest of all indide IP NAT ( PAT ) with one PUB_IP3.
Can all these MAP settings be done on router.
Please share the experience.
Any example of one-to-one NAT on router is highly appreciable.
Thanks in advance.
inside -> fa0/0 R1 fa0/1 -> outside
192.168.5.10 mapped to 18.104.22.168
192.168.6.10 mapped to 22.214.171.124
rest of inside addresses natted to 126.96.36.199
ip nat inside
ip nat outside
ip nat inside source static 192.168.5.10 188.8.131.52
ip nat inside source static 192.168.6.10 184.108.40.206
ip nat pool TPS 220.127.116.11 18.104.22.168 netmask 255.255.255.0
ip nat inside source list 101 pool TPS overload
access-list 101 permit ip any any