Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2656
Views
0
Helpful
3
Replies

Telnet source Loopback interface

Rupesh Kashyap
Level 1
Level 1

‎09-24-2009 05:57 PM - edited ‎03-04-2019 06:09 AM

Hi, I have two routers, R1 (S0/0-192.168.1.1 & Loopback-1.1.1.1) & R2 (s0/0-192.168.1.100 & Loopback-2.2.2.2). Now If I telnet R1 loopback 1.1.1.1 from R2, I am unable to do it. But if I use Loopback keywords as telnet source on R2, then I am able to telnet on R1 ( Command- R2#telnet 1.1.1.1 /source loopback0.) Please help why it is happening.

Labels:
0 Helpful
3 Replies 3

Lucien Avramov
Level 10
Level 10

‎09-24-2009 06:06 PM

You have issues with routes or access-lists.

Can you attach both show run outputs and I will tell you what is missing

0 Helpful

Rupesh Kashyap
Level 1
Level 1
In response to Lucien Avramov

‎09-24-2009 07:00 PM

Ok, I will check acl on vty. One thing more, same problem is when I ping the device. There is no acl on the interface, but I am able to ping only when source is loopback.

0 Helpful

Lucien Avramov
Level 10
Level 10
In response to Rupesh Kashyap

‎09-24-2009 07:05 PM

You have a routing issue most likely.

Can you attach your configs?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card