CME through PSTN Emulator to CME - call completes then rings busy

Unanswered Question
Sep 25th, 2009

Desired call flow:

H323 GW -> PSTN emulator via E1->inbound dial peer-> outbound dial peer -> different H323 GW via another E1

When dialing from H323 # 1 to H323 # 2, destination phone rings. As soon as call is answered, phone #1 starts playng busy signal.

debug voice dialpeer at all 3 locations shows correct dialpeer matching and correct call flow.

In my PSTN emulator, I have added voice service voip I have added H323 to H323.

All E1s show multiframe established.

In the reverse direction, the phone at GW 2 rings the phone at GW 1, the destination phone rings once and then the call drops

I can post any portions of the config if desired

Jeff

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion