CISCO CSS 11501

wfares · ‎09-27-2009

dear sir

i two Cisco CSS11501 they work in redundant i finish the configuration but when i try to access the application using the VIP it's fail with the att. is configuration for both CSS any help

jason.espino · ‎10-01-2009

Due to the following route statements on your CSS the servers response traffic is getting sent to IP/device 213.139.46.0.

ip route 213.139.46.35 255.255.255.255 213.139.46.0 1

ip route 213.139.46.36 255.255.255.255 213.139.46.0 1

Are the servers suppose to send their traffic to the 213.139.46.0 IP address? Or are they setup to use the 213.139.46.19 IP address as their gateway? If so, then the additional route statements should not be needed.

Also, have you verified the services have passed their keepalive check? Even though you have a URI of "/" and a keepalive port of "9080" on the services there is no keepalive type specified in the service configuration. The CSS should have defaulted to using ICMP keepaive check for the services.

- Jason