SSHv1 / SSHv2 support for Cisco IOS on VG224

csshenoy80 · ‎09-28-2009

Hi

We are trying to configure the SSHv1 or SSH v2 on VG224 with vg224 Software (vg224-I6S-M), Version 12.4(12)(vg224-i6s-mz.124-12), however there doesnt seem to be any supported commands on the IOS release.

Anyone tried SSH configuration on VG224 analog gateways, and which IOS release to be used?

Thanks.

Jaime Valencia · ‎09-28-2009

The IOS you're using does not support SSH

It needs the IP SUBSET/IPSEC 64 BIT/VOICE

The IOS name should contain a K9 in case it's enabled for it

IE

vg224-i6k9s-mz.124-15.T5.bin

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

csshenoy80 · ‎09-28-2009

Also, would this support SSH version 1 or 2?

Nicholas Matthews · ‎09-28-2009

With the k9 image it will support both v1 and v2.

-nick

csshenoy80 · ‎09-28-2009

Thank you java and nick !

bberry · ‎12-10-2012

I am running 12.4.22.T5 and can only get SSH V1 to operate. If I specify SSH V2 I get no connection. I am using a 2048 modulus on the key. Any thoughts?

Indu Gudipati · ‎02-15-2013

We have the same issue too, we have IOS vg224-i6k9s-mz.150-1.M3.bin and higher on our VG 224's .

Never able to get SSH v2 working on the them, SSH v1 works fine .

also we use a modulus 1024 key . Some body advise ??

---

Thanks,

Indu.