ASR 1006 Router CRIT Alarm

Unanswered Question
Sep 28th, 2009

Hi,

I have my new ASR 1006 router and there is a CRIT alarm (Critical) show on the front side of the Active Router/Active Sup.

I checked the ASR installation guide and found that this is apprearing at the startup but need to disable by software.

Ref: http://www.cisco.com/en/US/docs/routers/asr1000/quick/start/guide/asr1_qs6.html

Can someone advise me how to disable it from the command line?.

thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
scpage Mon, 09/28/2009 - 11:47

Have you tried...

show facility-alarm status

to identify what the critical alarm is and then fix.

You may be able to also use

clear facility-alarm

However, most likely it could be some issue such as failed power supply, etc that will not clear.

pemasirid Mon, 09/28/2009 - 23:51

Hi,

thanks for your response, the issue has been found and resolved. it was due to disconnectivity of one of the ports on interface. After connecting it the CRIT alarm disappeared. (this is at the staging level :))

thanks again for your reply.

Actions

This Discussion