Cannot load ASDM after upgrade

Answered Question
Sep 28th, 2009

Not sure where I slipped up, but when I try to load ASDM I get an unable to load ASDM from <ip address> message.

wbdcfw# sh ver

Cisco Adaptive Security Appliance Software Version 8.2(1)

Device Manager Version 6.2(1)

Compiled on Tue 05-May-09 22:45 by builders

System image file is "disk0:/asa821-k8.bin"

Config file at boot was "startup-config"

wbdcfw up 3 mins 2 secs

Hardware: ASA5505, 256 MB RAM, CPU Geode 500 MHz

Internal ATA Compact Flash, 128MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

...

I have this problem too.
0 votes
Correct Answer by platinum_jem about 7 years 2 months ago

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
platinum_jem Mon, 09/28/2009 - 21:28

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

godinerik Tue, 09/29/2009 - 01:14

You must also specify which addresses are allowed to access it:

http xx.xx.xx.xx netmask [interface] i.e:

http 192.168.100.0 255.255.255.0 inside

or

http 0 0 outside for all of the outside IPs. If all of that is done, clear your browser's cache/cookies, close all browser windows and re-open.

Actions

This Discussion