cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
759
Views
0
Helpful
3
Replies

Cannot load ASDM after upgrade

Not sure where I slipped up, but when I try to load ASDM I get an unable to load ASDM from <ip address> message.

wbdcfw# sh ver

Cisco Adaptive Security Appliance Software Version 8.2(1)

Device Manager Version 6.2(1)

Compiled on Tue 05-May-09 22:45 by builders

System image file is "disk0:/asa821-k8.bin"

Config file at boot was "startup-config"

wbdcfw up 3 mins 2 secs

Hardware: ASA5505, 256 MB RAM, CPU Geode 500 MHz

Internal ATA Compact Flash, 128MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

...

1 Accepted Solution

Accepted Solutions

platinum_jem
Level 1
Level 1

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

View solution in original post

3 Replies 3

platinum_jem
Level 1
Level 1

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

I didn't have 'http server enable' in my config. Thanks!

godinerik
Level 1
Level 1

You must also specify which addresses are allowed to access it:

http xx.xx.xx.xx netmask [interface] i.e:

http 192.168.100.0 255.255.255.0 inside

or

http 0 0 outside for all of the outside IPs. If all of that is done, clear your browser's cache/cookies, close all browser windows and re-open.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: