Cisco 878 Bridge Mode

Unanswered Question
Sep 29th, 2009

Hello,

I want to my use Cisco 878 Router as a Bridge and want to make the PPPoE authentication at my different brand firewall. is that possible ?

thanks for your all comments.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
erdalorsavas Tue, 09/29/2009 - 02:00

Hi,

please forgive my stupidity,

could you please give me a configuration example about it ?

erdalorsavas Tue, 09/29/2009 - 03:07

thanks for your fast reply,

when I try to do put fastethernet to bridge-group it says the following message:

HSM(config-if)#bridge-group 1

FastEthernet0 does not support bridging

is it a fixible issue ?

thank you so much.

erdalorsavas Tue, 09/29/2009 - 04:02

hi again,

sorry being headacke to you.

now my vlan1 is up bu I couldn't up my atm interface. it says down all the time.

do you have any idea why is that for ?

thanks a lot

erdalorsavas Tue, 09/29/2009 - 07:27

hi,

thank you for all your advices. it has been very helpful to me. I solved my problem. thank you again.

Actions

This Discussion