CME 4.1 issue

Answered Question
Sep 29th, 2009
User Badges:

I have an issue when i take a phone off hook i get a busy signal. I am sure it is something simple, but until i figure it out i am stuck. The phone generates the following error on the CME router:


*Sep 26 02:28:08.243: %CALL_CONTROL-6-APP_NOT_FOUND: Application telephony-service in dial-peer 20001 not found. Handing callid 5 to the alternate app .


I am assuming something with dial-peer configuration but cannot seem to get it resolve. Thanks in advance.

Correct Answer by Nicholas Matthews about 7 years 10 months ago

I'm not sure what could cause this problem - not familiar with this error message. You could start with removing telephony-service and ephone/ephone-dn, and re-adding. As well, a reload of the gateway.



-nick

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2.5 (2 ratings)
Loading.
Correct Answer
Nicholas Matthews Tue, 09/29/2009 - 10:01
User Badges:
  • Red, 2250 points or more

I'm not sure what could cause this problem - not familiar with this error message. You could start with removing telephony-service and ephone/ephone-dn, and re-adding. As well, a reload of the gateway.



-nick

m-martynowski Fri, 10/02/2009 - 17:24
User Badges:

i reinstalled CME from scratch and loading a config i knew worked. It ran fine after that. Not sure what was wrong, (i.e bad CME install or bad config) but either way functioning fine. THanks

Actions

This Discussion