09-29-2009 07:46 AM - edited 03-18-2019 10:38 AM
I have an issue when i take a phone off hook i get a busy signal. I am sure it is something simple, but until i figure it out i am stuck. The phone generates the following error on the CME router:
*Sep 26 02:28:08.243: %CALL_CONTROL-6-APP_NOT_FOUND: Application telephony-service in dial-peer 20001 not found. Handing callid 5 to the alternate app .
I am assuming something with dial-peer configuration but cannot seem to get it resolve. Thanks in advance.
Solved! Go to Solution.
09-29-2009 10:01 AM
I'm not sure what could cause this problem - not familiar with this error message. You could start with removing telephony-service and ephone/ephone-dn, and re-adding. As well, a reload of the gateway.
-nick
09-29-2009 08:18 AM
Which IOS version are you on?
09-29-2009 09:24 AM
12.4.15T
09-29-2009 10:01 AM
I'm not sure what could cause this problem - not familiar with this error message. You could start with removing telephony-service and ephone/ephone-dn, and re-adding. As well, a reload of the gateway.
-nick
10-02-2009 05:24 PM
i reinstalled CME from scratch and loading a config i knew worked. It ran fine after that. Not sure what was wrong, (i.e bad CME install or bad config) but either way functioning fine. THanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: