09-29-2009 11:24 PM - edited 03-15-2019 05:09 AM
hello,
is there any configuration needed for a pvdm in a voice gateway?
thanks
09-30-2009 12:06 AM
You don't need any config when you use it with for example with T1/E1 line. You will need to create dspfarm for transcoder, so depends what you need.
09-30-2009 01:32 AM
sounds interesting..but could you elaborate further pls
09-30-2009 06:41 AM
Hi,
Voice termination applies to a call that has two call legs, one leg on a time-division multiplexing (TDM) interface and the second leg on a Voice over IP (VoIP) connection. The TDM leg must be terminated by hardware that performs coding/decoding and packetization of the stream. This termination function is performed by digital signal processor (DSP) resources residing in the same hardware module, blade, or platform. All DSP hardware on Cisco TDM gateways is capable of terminating voice streams, and certain hardware is also capable of performing other media resource functions such as conferencing or transcoding (see Audio Conferencing and Transcoding).
For more about Media Resources:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/media.html
Hope it helps, if it does please rate.
Best regards,
- Adrián.
09-30-2009 07:26 AM
thanks adrian..
if we say that a pvdm2-32 is used, how will the configuration looks like if we proposed to use it with
-voice termination
-as well as transcoder
-audio conference bridge
09-30-2009 07:45 AM
Hi,
You can read this docs for good information and examples:
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html
Hope it helps, if it does please rate.
Best regards,
- Adrián.
09-30-2009 08:47 AM
thanks adrian..pls see my other post re; voice termination config..it is not mentioned on your above configuration examples
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: