09-30-2009 02:14 AM - edited 03-06-2019 07:56 AM
Hi,
Recently I enabled a multicast group to connect to a different rp-address. Following that all subscriber traffic was via the new rp. However, I had a problem and as a result I had to disable this new rp setup. I removed the rp configuration from the switch i.e "no ip pim rp-address 10.20.3.2 WAN-GROUPS". After this I looked at the output from "show ip mroute" and I saw the traffic was still being sent via the new rp.
Can someone explain this, do I need to reload or clear some table?
Thanks
Dan
Solved! Go to Solution.
09-30-2009 02:25 AM
Hi Dan.
The multicast streams will stay in place until they age out, although it will not make much of a difference as with default settings the multicast tree will change to source based anyway.
If you need to see a difference try 'clear ip mroute *'
(or you can use the same command but specify the particular groups)
Simon
09-30-2009 02:25 AM
Hi Dan.
The multicast streams will stay in place until they age out, although it will not make much of a difference as with default settings the multicast tree will change to source based anyway.
If you need to see a difference try 'clear ip mroute *'
(or you can use the same command but specify the particular groups)
Simon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: