But what if it is beeing used also as trancoder?

Not sure what you mean if you don't provide a clear explanation

If you mean you want to share voice termination and XCODER it's possible (As long as you have enough DSPs for both of course)

HTH

java

if this helps, please rate

Hi Celso,

Sorry for not follow up the other post about this topic.

As Java said, it doesn't need configuration.

To answer your last question:

You allocate DSP resources either to voice termination of the voice trunk group or to the DSP farm. Occasionally these allocations can conflict.

If you previously allocated DSP resources to voice termination (this must be done first) and you now try to configure a DSP farm, you might find that insufficient DSP resources are available. Conversely, if you previously allocated DSP resources to a DSP farm and you now try to configure a trunk group, you might find that insufficient DSP resources are available.

Hope it helps, if it does please rate.

Best regards,

- Adrián.

is it possible to provide sample configuration of the above mentioned scenario?

thanks

Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html

Capacity planning and full explanation is on the link.

HTH

java

if this helps, please rate

hi java,

i couldnt see any config of mix voice termination and transcoder/conf bridge.

again... there is NO config for voice termination. Adrián also explained this.

You DO NEED to configure XCODER or CFB, for that, refer to the link

HTH

java

if this helps, please rate

pls have a look on my other post titled

'pvdm2 enable on 2800 main board'