E1 R2 between 2811 and Nortel 11C receiving dialed digits

Unanswered Question
Sep 30th, 2009
User Badges:

Hi, i have a problem. When i make calls from Callmanager to PBX Nortel works. But calls from PBX Nortel to Callmanager there a delay a couple seconds then i hear dial tone ,i dial the number and works.Any idea?


PBX Nortel--E1R2---GW2811--Callmanager


PBX Nortel 11C rls 81

Gw2811 IOS c2800nm-spservicesk9-mz.124-3i

Callmanager 5.1.3

Regards



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Buffin Wed, 09/30/2009 - 11:43
User Badges:
  • Purple, 4500 points or more

Sounds like you need an inbound dial peer with "direct-inward-dial" such as:


dial-peer voice 1 pots

incoming called-number .

direct-inward-dial


Hope this helps.


Brandon

paolo bevilacqua Wed, 09/30/2009 - 14:48
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

As Brandon said, this is caused by need of direct-inward-dial. may be you have another pots DP being matched before DP 1, need to check config.

Brandon Buffin Thu, 10/01/2009 - 04:14
User Badges:
  • Purple, 4500 points or more

Run "debug voip dialpeer" and see what dial peer is being matched.


Brandon

cristian.munoz Thu, 10/01/2009 - 06:11
User Badges:

Dear Brandon


Now is working. I saw in the debug voip dialpeer that the PBX send a five digit. I put a num-exp and all works.

Thanks a lot!

Actions

This Discussion