09-30-2009 11:30 AM - edited 03-18-2019 10:39 AM
Hi, i have a problem. When i make calls from Callmanager to PBX Nortel works. But calls from PBX Nortel to Callmanager there a delay a couple seconds then i hear dial tone ,i dial the number and works.Any idea?
PBX Nortel--E1R2---GW2811--Callmanager
PBX Nortel 11C rls 81
Gw2811 IOS c2800nm-spservicesk9-mz.124-3i
Callmanager 5.1.3
Regards
09-30-2009 11:43 AM
Sounds like you need an inbound dial peer with "direct-inward-dial" such as:
dial-peer voice 1 pots
incoming called-number .
direct-inward-dial
Hope this helps.
Brandon
09-30-2009 12:50 PM
Hi Brandon, but the problem still continue.
Regards
09-30-2009 02:26 PM
09-30-2009 02:48 PM
As Brandon said, this is caused by need of direct-inward-dial. may be you have another pots DP being matched before DP 1, need to check config.
10-01-2009 04:14 AM
Run "debug voip dialpeer" and see what dial peer is being matched.
Brandon
10-01-2009 06:11 AM
Dear Brandon
Now is working. I saw in the debug voip dialpeer that the PBX send a five digit. I put a num-exp and all works.
Thanks a lot!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: