CUE 3.1 upgrade and flash

Answered Question
Sep 30th, 2009

Hi all,

I need to upgrade a AIM-CUE 3.1, to hopefully 7.1.x. question:

1, according to Cisco docs, if the AIM-CUE has got 512MB compact flash, it needs to upgrade to 1G first. how do I check the how much is the flash now? I went through all the commands and even "show tech" on the module, can't find the flash size.

2, if I do a upgrade (not clean install), do I need to do anything about licenses??

thanks

I have this problem too.
0 votes
Correct Answer by Hythim Ali El Hadad about 7 years 3 months ago

Hi,

1. you can use show voicemail limits

if System Capacity (minutes): 480

then it is 512

480/60=8-hours storage

if 14-hour storage ,then it is 1GB

2. no

wish this be helpful

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Hythim Ali El Hadad Thu, 10/01/2009 - 08:17

Hi,

1. you can use show voicemail limits

if System Capacity (minutes): 480

then it is 512

480/60=8-hours storage

if 14-hour storage ,then it is 1GB

2. no

wish this be helpful

Hythim Ali El Hadad Thu, 10/01/2009 - 12:48

hi,

this may clarify my post above:

CUE#show voicemail limits

Default Mailbox Size (seconds): 420

Default Caller Message Size (seconds): 60

Maximum Recording Size (seconds): 900

Default Message Age (days): 30

System Capacity (minutes): 480

Default Prompt Language: en_US

Operator Telephone: 0

wish this be helpful

minghui.qi Thu, 10/01/2009 - 21:30

Thanks! I ran that commands, it shows the system capacity as 800 min, so I guess it's a 1GB flash one.

For the license, I found that since CUE 7.1, the licensing changes to the new scheme, you buy the mailbox license in increments of 5, etc. I thought since it's different from before, don't you need to get new license file or something like that??

Hythim Ali El Hadad Fri, 10/02/2009 - 06:53

Hi,

yes

I have an upgrade like that lately

and i didn't deal with any upgrade license file

it is only if you'll change the no. of supported mail boxes

wish this be helpful

thanks

Adrian Saavedra Thu, 10/01/2009 - 10:02

Hello,

I believe you can see compact flash information with show version from cue prompt.

Hope it helps, if it does please rate.

Best regards,

- Adrián.

minghui.qi Thu, 10/01/2009 - 21:34

thanks for your reply, I thought the show version command would show it, but it shows SDRAM not flash size.

Actions

This Discussion