LAP not joining the controller

Unanswered Question
Oct 1st, 2009
User Badges:

Gents


I have 1 AP out of ten not joining the controller. I connected the access point to the network and I checked its boot. the access point reaches LWAPP Discovery" and then give me console input. I hard reset the access point and I hard coded an IP address for the AP the AP joins the controller, but when I reset it to assign it to another controller it did not join again.


why the discovery process is not showing the DHCP option 43 configured and DNS for CISCO-LWAPP-CONTROLLER configured on the DNS. All the access point is operating normally except this one. it has many certificate inside, why a hard reset did not work to solve the problem?

Please advise

Thanks,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Thu, 10/01/2009 - 15:20
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Does the LAP have a valid IP address?

Can the LAP ping the WLC managment IP address?

Console into the LAP and in enable mode, type the command "lwapp ap controller ".

Actions

This Discussion