Configuration Cisco IP Phone

supportalliacom · ‎10-02-2009

Hello,

I have a Cisco UC520, Cisco IP Phones (7911, 7941, 7931) and my switched network is done with Nortel BES 1010.

I have configured two VLAN (voice and data), and a trunk between the UC520 and the Nortel Switch.

I don't Know how to configure on the Cisco IP Phone, the VLAN voice PVID.

When I make the test with Cisco switch, it's ok with command #switchport voice vlan 100, CDP detect autommatically the IP Phone.

How to configure the IP Phone with the VLAN voice PVID physically on the Cisco IP Phone?

Thanks for your help.

LC

David Harper · ‎10-02-2009

On the phone, select Settings > Network Setting > Admin VLAN ID. To edit this field you will invariably need to unlock the settings by keying in '**#' first.

Cheers,

Dave.

supportalliacom · ‎10-02-2009

Thank you very much

Aayush1806 · ‎04-03-2023

Hello Everyone

Thanks to Cisco Community

I have a similar problem. I configured My router and switches but 2 phones are able to get the ip address from DHCP but other 2 phone cannot. I have added my topology to check and my configuration. All PC's can ping.

Configurations:

12345

The problem is Ipphone3 and Ipphone4 both are not configuring. If someone can help me please.