Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Corlist on UC500

Unanswered Question
Oct 2nd, 2009
User Badges:

Hi all,

I have question regarding steup corlist on Cisco UC500 with CLI.

Outgoing calls are routed via a SIP trunk from a generic SIP provider.

There is my config :

dial-peer cor custom
name national
name gsm
name international
name urgence


dial-peer cor list droits-limites
member national
member urgence


dial-peer voice 1015 voip
corlist outgoing droits-limites
description Appels Locaux
translation-profile outgoing OUTGOING_TRANSLATION_PROFILE
preference 1
destination-pattern 0[1-59]........
session protocol sipv2
session target sip-server
dtmf-relay rtp-nte
no vad

ephone-dn  4  dual-line
number 847
label 847
description TOTO
name TOTO
allow watch
corlist incoming droits-limites
transfer-mode consult


I have another dial-peer with no corlist configured.

When i make an outgoing call, It match with dial-peer wich have no corlist configured.

have you any idea ?

Thanks all.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Steven Smith Fri, 10/02/2009 - 08:30
User Badges:
  • Gold, 750 points or more

Does the other dial peer have a perference of 0 (which would mean no preference)?

If you do not have a cor list configure on the ephone-dn or the dial-peer, they are available to anyone.

Here is all the information you need to know about the subject.


Joseph Chambers Fri, 10/02/2009 - 08:32
User Badges:

You will need to apply to all dial peers if you want to restrict access.

I've attached something - its for US but you should be able to see correlation.

wbourguibartic Fri, 10/30/2009 - 07:04
User Badges:


Thanx for response guys, I had no time to configure it.

I will test it and give response asap.

Best regards.


This Discussion