10-02-2009 08:25 AM - last edited on 03-25-2019 10:41 PM by ciscomoderator
Hi all,
I have question regarding steup corlist on Cisco UC500 with CLI.
Outgoing calls are routed via a SIP trunk from a generic SIP provider.
There is my config :
dial-peer cor custom
name national
name gsm
name international
name urgence
!
dial-peer cor list droits-limites
member national
member urgence
!
dial-peer voice 1015 voip
corlist outgoing droits-limites
description Appels Locaux
translation-profile outgoing OUTGOING_TRANSLATION_PROFILE
preference 1
destination-pattern 0[1-59]........
session protocol sipv2
session target sip-server
dtmf-relay rtp-nte
no vad
!
ephone-dn 4 dual-line
number 847
label 847
description TOTO
name TOTO
allow watch
corlist incoming droits-limites
transfer-mode consult
!
I have another dial-peer with no corlist configured.
When i make an outgoing call, It match with dial-peer wich have no corlist configured.
have you any idea ?
Thanks all.
10-02-2009 08:30 AM
Does the other dial peer have a perference of 0 (which would mean no preference)?
If you do not have a cor list configure on the ephone-dn or the dial-peer, they are available to anyone.
Here is all the information you need to know about the subject.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml
10-02-2009 08:32 AM
10-30-2009 07:04 AM
Hello,
Thanx for response guys, I had no time to configure it.
I will test it and give response asap.
Best regards.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: