Solved: Setting Up a PUB/SUB CM 7.0 server

BALAMURUGAN SINGARAM · ‎10-03-2009

I hava install PUB first; name - cucumpub, IPAddres - 192.168.100.1 GW - 192.168.100.10

then try install SUB - ; name - cucmsub, ipaddress 192.168.100.2 GW - 192.168.100.10

I am not having DNS server in this installation, when I try to install SUB, it says name cucumpub does not exist, I am able to ping both server...from my switch and laptop, please light me how to install SUB ; pointing the PUB.

Rob Huffman · ‎10-04-2009

Hi Bala,

Just to add a note to the great tips from Gonz (+5 points my friend :)

When you perform a fresh installation of Cisco Unified Communications Manager, you must define any subsequent servers (nodes) in the Cisco Unified Communications Manager Administration Server Configuration window before you can install Cisco Unified Communications Manager on each subsequent server. To define a subsequent node, click Add New, and perform the procedure in the "Configuring a Server" section. After you add the subsequent server, you can then install the Cisco Unified Communications Manager software on that server.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/7_0_1/ccmcfg/b02servr.html#wp1020200

Installing Cisco Unified Communications Manager on a New Subscriber Server

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/7_0_1/cluster/clstr701.html#wp97669

Hope this helps!

Rob

View solution in original post

gogasca · ‎10-03-2009

did u already add sub under system server?

apart from not dns server, did u use dns suffix like cucmpub.cisco.com? if so thats the problem

if u got to pub do show network eth0 detail

and show status to show u all details

BALAMURUGAN SINGARAM · ‎10-04-2009

do you say before installing the SUB, should I add SUB ip address in Publisher, please correct me if my understanding is wrong. I will try that now.

Rob Huffman · ‎10-04-2009

Hi Bala,

Just to add a note to the great tips from Gonz (+5 points my friend :)

When you perform a fresh installation of Cisco Unified Communications Manager, you must define any subsequent servers (nodes) in the Cisco Unified Communications Manager Administration Server Configuration window before you can install Cisco Unified Communications Manager on each subsequent server. To define a subsequent node, click Add New, and perform the procedure in the "Configuring a Server" section. After you add the subsequent server, you can then install the Cisco Unified Communications Manager software on that server.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/7_0_1/ccmcfg/b02servr.html#wp1020200

Installing Cisco Unified Communications Manager on a New Subscriber Server

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/install/7_0_1/cluster/clstr701.html#wp97669

Hope this helps!

Rob