PSTN calls

Unanswered Question
Oct 5th, 2009
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

Hi All,


We are facing a problem while making PSTN calls to outside world using Cisco 2800 router configured as H.323 Gateway & integrated to Call Manager version 4.x.


On the router we have , VWIC-2MFT-E1 card on which PRI is terminated.


Setup was working fine but now when we call up, we need to dial two or 3 times before call gets matured.


router detail : c2800nm-spservicesk9-mz.123-11.T10.bin



can somebody guide on the same...


regds,

aman


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
KonradStepniewski Mon, 10/05/2009 - 02:11
User Badges:
  • Silver, 250 points or more

Check status of your e1 line.

Show controller e1 x/x brief and show isdn service.


you can run debug isdn q931 and check what's going on as well.

nesharm2 Mon, 10/05/2009 - 05:55
User Badges:
  • Bronze, 100 points or more

Aman,


Apart from good suggestions from konrad

good things to check

1.what changed if it was working before ?

2.Did you have "direct indward dial" command under pots dial peer ?

Justin Brenton Mon, 10/05/2009 - 08:45
User Badges:
  • Silver, 250 points or more

Can you post the results of


sh isdn status

sh voice dsp

sh voice call summary



Do you know how many B and D channels you have on your PRI, could be possible that your using all the channels available on the PRI.



Regards,

Justin

Actions

This Discussion