cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
397
Views
0
Helpful
2
Replies

Tunnel goes down

ericdegboevi
Level 1
Level 1

Hi All,

I have configured a site to site VPN with a cisco ASA 5510.

I was able to setup the VPN. Phase1 & Phase2 are all up and traffic can pass.

What i notice is that from time to time the tunnel goes down and the remote site will have to send a continue ping to my destination IP (IP in the ACL) before the tunnel comes up again.

Can you help on solving this issue?

Thanks

2 Replies 2

JORGE RODRIGUEZ
Level 10
Level 10

See ISAKMP Keepalives , enable it at both ends.

http://www.cisco.com/en/US/products/ps6120/products_tech_note09186a00807e0aca.shtml#Solution4

Jorge Rodriguez

"isakmp keepalive

threshold 15 retry 10"

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card