WiSM Module powered off

Unanswered Question
Oct 6th, 2009
User Badges:

I am using a Fan Module 1 on a 6509 chassis and it is giving me an error of insufficient cooling, is there a way around it or do I need Fan Blade 2??


Also how can turn on the WiSM Module?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Lucien Avramov Tue, 10/06/2009 - 12:36
User Badges:
  • Red, 2250 points or more

You can issue an hw-module boot or hw-module reset

If you need additionnal get it, you should not try to work around such need.



fmirza007 Tue, 10/06/2009 - 12:40
User Badges:

I tried that command but this is what I am getting;


Router#hw-module module 6 reset

Proceed with reload of module?[confirm]

% module 6 is operationally off (insuff cooling capacity)


any ideas?

da.beaver Wed, 10/07/2009 - 08:20
User Badges:

What version of Code are you running? Also what SUP module is in the chassis?

Lucien Avramov Wed, 10/07/2009 - 08:40
User Badges:
  • Red, 2250 points or more

you need to add a fan in your cat6k chassis in the fan slot.

Leo Laohoo Tue, 10/06/2009 - 14:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Did you just newly-insert the WiSM? By default, power to the module is turned off until enabled by using the command

"power enable module ".


Hope this helps.

fmirza007 Wed, 10/07/2009 - 10:02
User Badges:

I tried that command and nothing happened. I am thinking I do need fan blade 2 to get this going...


on the side not what is the command to combine the power supply output instead of the redundant mode..?

Leo Laohoo Wed, 10/07/2009 - 14:16
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

If you look at your chassis now, do you see a green status lamp of the WiSM? If not, then it's not getting power. What is the result if you do a "show module"?


sh power status power-supply <1 or 2>

Actions

This Discussion

 

 

Trending Topics - Security & Network