10-06-2009 12:18 PM - edited 07-03-2021 06:07 PM
I am using a Fan Module 1 on a 6509 chassis and it is giving me an error of insufficient cooling, is there a way around it or do I need Fan Blade 2??
Also how can turn on the WiSM Module?
10-06-2009 12:36 PM
You can issue an hw-module boot or hw-module reset
If you need additionnal get it, you should not try to work around such need.
10-06-2009 12:40 PM
I tried that command but this is what I am getting;
Router#hw-module module 6 reset
Proceed with reload of module?[confirm]
% module 6 is operationally off (insuff cooling capacity)
any ideas?
10-07-2009 08:20 AM
What version of Code are you running? Also what SUP module is in the chassis?
10-07-2009 08:40 AM
you need to add a fan in your cat6k chassis in the fan slot.
10-06-2009 02:58 PM
Did you just newly-insert the WiSM? By default, power to the module is turned off until enabled by using the command
"power enable module
Hope this helps.
10-07-2009 10:02 AM
I tried that command and nothing happened. I am thinking I do need fan blade 2 to get this going...
on the side not what is the command to combine the power supply output instead of the redundant mode..?
10-07-2009 02:16 PM
If you look at your chassis now, do you see a green status lamp of the WiSM? If not, then it's not getting power. What is the result if you do a "show module"?
sh power status power-supply <1 or 2>
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: