10-06-2009 02:58 PM - edited 03-15-2019 07:56 PM
I am trying to configure a 2811 to send calls from a pri to a sip trunk. I have a dial-peer built that seems to be working sip to sip. I am having trbl getting the call to go from int s0/0/0:23 out to the fa 0/1 port. That is connected to the sip provider. Any help ... I know I have not gave much info I can answer your questions please help...
10-06-2009 05:31 PM
Try looking at the CVP install instructions. There are some examples there. I would post the config but I am still recovering from a HD failure but I have seen some examples in the CVP guides
10-06-2009 07:38 PM
Need more details to troubleshoot.
Good chance it's a simple dial peer translation / caller id problem. debug ccsip messages helps.
There shouldn't be any special config to get PRI-SIP to work, especially if SIP-SIP is already working.
-nick
10-07-2009 06:11 AM
Sorry guys. I am not getting any messages from the pstn on q931 or ccsip. What happens is when the pstn (which I work for) sends the call I get a secondary dial tone. Never any messages! I have attached a copy of the config minus the ip address's. This is a new turn up on both pri to sip and sip to sip. Any help is appreciated... Thanks...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: