I have a strange problem at a site where inbound dialing into the CME 4.1 works fine. 3 POTS lines into an FXO card. Outbound dialing either gives fast busy or "number has been disconnected". If i do a debug on dial peer it looks like everything is working. Tested from the telco demarc and works fine without CME in the mix. Anyone run into something like this before? CME 4.1, IOS 12.4.15T. Thanks in advance
Make sure your dial-peers are correct and you're sending the necessary digits, if they're correct do a debug voip ccapi inout to find who and why the call is dropped
Make sure your dial-peers are correct and you're sending the necessary digits, if they're correct do a debug voip ccapi inout to find who and why the call is dropped
i attached the debug, can you look through it and see what you think?
Preview file
22 KB
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
