H323 advice

Answered Question
Oct 7th, 2009

It may be a stupid question but my brain is dead at the moment

I have GW 1 registered to a CCM using MGCP which in turn connects to GW2 using a E1 WIC on each GW with RJ45 cable between them. GW2 then provides VOIP dial-peer pointing to other GW`s in our Clound - this second GW is not registered to CCM.

Question - I want to do away with the first MGCP GW and the physical RJ45 conenction and connect directly to the second GW wihtout any physical connection ,almost like Gatekeepe,Trunk connection - can I configure the GW2 as a H323 device on CCM and use VOP dial-peers to point back to CCM ?


I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 7 years 3 weeks ago

Yes, absolutely.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
iptuser55 Wed, 10/07/2009 - 04:44

Thanks for the quick answer

CUCM DN`s 1...

Do I just add a H323 GW in CCUM and on the GW do I

create Dial-peer voice xxxx voip

Destination-Pattern 1...

Session TargetIPV4:X.X.X.X- CUCM IP address

Outbound to Clound

Dial-peer voice YYYY VOIP

Destinatio-Patterns 2...

session target ipv4:- next GW

Is this ok ?


This Discussion