10-07-2009 04:33 AM - edited 03-04-2019 06:17 AM
Hi ,
Cisco Feature navigator says it supports IPv6 on following IOS & Model.
System image file is "flash:c2800nm-advsecurityk9-mz.124-15.T7.bin"
Cisco 2811 (revision 53.51) with 249856K/12288K bytes of memory.
But
i cannot run "ipv6 unicast-routing" command
also i am not able to assign ipv6 addresses to any of the interfaces. !!!
Anybody has any idea ? in fact it does not give me any ipv6 option from CLI ( neither privilege nor global config )
Also , can i run DHCP for IPv6 on Cisco 2811 router with above IOS ?
10-07-2009 06:02 AM
Satish,
I just checked the Feature Navigator and it actually says that you either need ADVANCED ENTERPRISE SERVICES or ADVANCED IP SERVICES to run ipv6 on the 2811. ADVANCED SECURITY SERVICES will not do it.
Regards
10-08-2009 12:35 AM
Yeah , i checked it again , you are right...
:)
Thanks
03-18-2015 11:31 AM
i just ran into the same thing....
12.2(10a) won't run it on a 2600 either?....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: