Cisco ISR (sh conn ???)

Unanswered Question
Oct 7th, 2009

hi,

I'm migrating all my cisco PIX used as VPN peers by Cisco ISR routers.

I would like to refind a bit same information.

does it exist something like "sh conn" on routers ? to see all connections : udp, tcp, icmp.. ?

if you know how to get that, I'm interested.

thanks

regards

Nicolas

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Collin Clark Wed, 10/07/2009 - 05:37

Nicolas,

show ip nat translations

Below are sub-options as well.

global Display entries in Global/Dest Table - NVI

icmp Show ICMP entries

pptp Show PPTP entries

tcp Show TCP entries

udp Show UDP entries

verbose Show extra information

vrf Display entries of VRF instance

| Output modifiers

nvanhaute Wed, 10/07/2009 - 05:41

hi,

thanks, but like I said before I use ISR only as VPN peers, so there is none nat

Nicolas

Collin Clark Wed, 10/07/2009 - 05:52

Sorry about that. Try enabling IP Accounting. That should give you the connections you're looking for. I'm not 100% sure it will give you the port numbers though.

nvanhaute Wed, 10/07/2009 - 06:01

thanks that works well on my tunnel interfaces

you are right, there is no port indication :-( (if you have an idea)

but it's not real time traffic, right ? it keeps history :-(

it's better than nothing, but I try to find better

thx

Nicolas

Actions

This Discussion