DS3 Connection

Unanswered Question
Oct 7th, 2009
User Badges:

Hello Everyone,


with an NM-1T3/E3 Netowkr module other than issuing the card type command, assiging an IP address and issuing the no shut command on the now created Serial interface is there anything else that needs to be done to bring up a DS3 connection?


Thanks in advance! ALl replies rated

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Collin Clark Wed, 10/07/2009 - 07:36
User Badges:
  • Purple, 4500 points or more

The DSU bandwidth and framing are critical. Here's an exmaple of my interface config.


interface Serial2/0

description [Circuit ID]

ip address a.b.c.d 255.255.255.252

no ip proxy-arp

encapsulation ppp

ip route-cache flow

ntp disable

dsu bandwidth 40300

framing c-bit

cablelength 250

serial restart-delay 0

no cdp enable


Hope that helps.

Actions

This Discussion