Nokia E serious Phone integration with CCM 4.1.3

Unanswered Question
Oct 8th, 2009


I have one doubt, i can integrate nokial phones with CCM Version 4.1.3.

If its possible pls share some information about it.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
virverma Thu, 10/08/2009 - 17:45

Not sure if it is possible for CCM 4.1 but it starts from cucm 6.X

Below is general configuration, I found, not sure if it is supported by cisco but if you want to test, you can check it,

On Call Manager


Under User Management ->End User, set the Digest Credential password for

a user that will use the SIP handset.

On the Phone configuration page, use the following parameter :

MAC Address :(MAC address of the SIP IP Phone)

Device Pool : (your device pool)

Phone button template : Third-Party SIP Device (Basic)

SIP Phone security profile : Non Secure SIP Profile auth by string

SIP Profile : Standard SIP Profile

Digest User : (same one as you set digest credentials)

On Nokia


Profile name: (you decide)

Service Profile: IETF

Default Access Point: (define the access point)

Public user name: @

Use Compression: No

Registration: Always On

Use Security: no

Proxy server settings

Proxy server address: sip:(your callmanager IP)

Realm: ccmsipline

User name:


Allow loose routing: Yes

Transport Type: UDP

Port: 5060

Registrar Server Settings

Registrar serv. addr.: sip: (your callmanager IP)

Realm: ccmsipline

User Name:


Transport Type: UDP

Port: 5060

Another option is to use Nokia Call Connect (NCC), using this you can

register your Nokia phone as a SCCP phone on CallManager. You can find

more information about this on the following links:


Please rate if this helps


This Discussion