Could not apply changes Cisco IDSM-2 via gui (IDM)

Unanswered Question
Oct 8th, 2009

Expert,

We encountered issue with applying changes via the IDM but it's ok via cli. Is this a known issue with IDSM? I have attached the system info.

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
k.ramalingam Sat, 10/10/2009 - 21:20

no any error shown. When you tried to apply changes it doesn't do anything and when you tried to move to another screen, it indicate you need to save the config 1st which we can't.

Farrukh Haroon Sat, 10/10/2009 - 22:03

You just have to click on "Apply Changes" if you made any changes on that tab. The changes will then become applied. Maybe the GUI loaded config became inconstistent, click on the 'Refresh' button to get the saved config and then make any changes.

Regards

Farrukh

Actions

This Discussion