How to enable SSH nad nating at the same time

Unanswered Question
Oct 11th, 2009


The problem is i have a static ip on router interface and it is configured for pating.

But i can't ssh to the public ip address unless i remove the IP nat outside on the wan interface.

Is there a solution to this issue?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Paolo Bevilacqua Sun, 10/11/2009 - 03:09

Please check the ACL used in "ip nat inside source" command. If it contains "any", that is the cause.


This Discussion