Line clock settings 2Mb leased line

Answered Question
Oct 11th, 2009
User Badges:

Hi


Believe it or not but a providor in Norway delivers not a clock signal in a point to point 2 Mb leased line.

What is now the best way to configure the clock setting on both routers ?

Normaly the config is; clock source internal But must you set that on both sides or only on one? And how do know that than both clocks are in sync ?

Correct Answer by Giuseppe Larosa about 7 years 7 months ago

Hello Rene,

use clock source internal on one side and clock source line on the other side.


This should be fine.


>> And how do know that than both clocks are in sync ?


there is no direct way to see this you need to consider interface statistics over time if some type of interface errors don't increment over time clocking should be correct.


see


http://www.cisco.com/en/US/docs/internetworking/troubleshooting/guide/tr1915.html


for T1/E1


http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml


Hope to help

Giuseppe


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Giuseppe Larosa Sun, 10/11/2009 - 22:09
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Rene,

use clock source internal on one side and clock source line on the other side.


This should be fine.


>> And how do know that than both clocks are in sync ?


there is no direct way to see this you need to consider interface statistics over time if some type of interface errors don't increment over time clocking should be correct.


see


http://www.cisco.com/en/US/docs/internetworking/troubleshooting/guide/tr1915.html


for T1/E1


http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml


Hope to help

Giuseppe


r.vanschendel Sun, 10/11/2009 - 22:16
User Badges:

Hi Giuseppe


Thanks for your time and the answer. It is what I expected, but now I am sure.

Actions

This Discussion