10-12-2009 02:45 AM - edited 03-06-2019 08:05 AM
Good All
How do I check what devices are plugged into my switch. Which commands can I use to get the mac addresses of the devices plugged in?
10-12-2009 03:34 AM
Hi,
The command is show mac-address-table
Best regards.
Massimiliano.
10-12-2009 01:21 PM
"sh mac-address-table" is the command, however, this will give you a very, very long list.
If you know a specific port, you can use the subcommand "sh mac-address-table interface
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide