10-12-2009 02:45 AM - edited 03-06-2019 08:05 AM
Good All
How do I check what devices are plugged into my switch. Which commands can I use to get the mac addresses of the devices plugged in?
10-12-2009 03:34 AM
Hi,
The command is show mac-address-table
Best regards.
Massimiliano.
10-12-2009 01:21 PM
"sh mac-address-table" is the command, however, this will give you a very, very long list.
If you know a specific port, you can use the subcommand "sh mac-address-table interface
Hope this helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: