reload a cisco router via snmp

Unanswered Question
Oct 12th, 2009


I am trying to reload a cisco router via SNMP. snmp-server system-shutdown is enabled on the router. I run the snmp get and it says message done but than nothing happens. What else is missing?



[[email protected] odriscm2/] $ snmpget -c w2e37uh1 .

cisco.local.lts.tsMsgSend.0 : INTEGER: messagedone

[[email protected] odriscm2/] $

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Mon, 10/12/2009 - 07:04

What was the SNMP Set command you used to set tsMsgSend? What version of IOS is running on this device?


This Discussion