10-12-2009 09:36 PM
Hi
I have over 100 switches in the network
and I would like to get the serial number for Gbic in each switches
How can I use LMS to show the serial number of Gbic ?
Can I use Inventory Report in RME for this case ?
Thank you.
10-13-2009 05:06 AM
Unfortunately, I don't think this has changed in LMS. See this previous discussion on the subject:
http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc29934/2#selected_message
Though you could use the NetShow function of RME to collect such info against individual interfaces on a rather hit-or-miss basis:
show interface status
show interface gigabitEthernet
show controller ethernet-controller gigabitEthernet phy
show inventory
10-13-2009 07:24 AM
This is correct. I have a bug open requesting this support, but it has not been implemented yet. The bug ID is CSCsz48654.
10-13-2009 04:09 PM
Thank you very much
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
