cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
529
Views
10
Helpful
3
Replies

How does LMS show the serial number of Gbic

araya.jirapinyo
Level 1
Level 1

Hi

I have over 100 switches in the network

and I would like to get the serial number for Gbic in each switches

How can I use LMS to show the serial number of Gbic ?

Can I use Inventory Report in RME for this case ?

Thank you.

3 Replies 3

yjdabear
VIP Alumni
VIP Alumni

Unfortunately, I don't think this has changed in LMS. See this previous discussion on the subject:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cc29934/2#selected_message

Though you could use the NetShow function of RME to collect such info against individual interfaces on a rather hit-or-miss basis:

show interface status

show interface gigabitEthernet

show controller ethernet-controller gigabitEthernet phy

show inventory

This is correct. I have a bug open requesting this support, but it has not been implemented yet. The bug ID is CSCsz48654.

Thank you very much

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco