Identifying oice traffic using ACL's

Unanswered Question
Oct 13th, 2009
User Badges:

Hi ,

Can you please advise how to identify Voice traffic using ACL's.


I need to identify voice traffic and then use route map to route traffic over preferred path.


Any sample config will help.

thanks


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
virverma Wed, 10/14/2009 - 12:19
User Badges:
  • Silver, 250 points or more

You can try this,


you can use this ACL to pick up voice and H323 signalling packets.



access-list 102 permit udp any any range 16384 37276

access-list 103 permit tcp any eq 1720 any

access-list 103 permit tcp any any eq 1720


Where,

access-list 102 matches VoIP traffic based on the UDP port range.

access-list 103 matches VoIP signaling protocol. In this case, H.323 V2 is uesd with the

fast start feature.


Then we just need to apply this to a route-map and the interface:


a) Define a route-map for traffic to go to next-hop 6.6.6.6


route-map equal-access permit 10

match ip address 102

set ip default next-hop 6.6.6.6


route-map equal-access permit 20

match ip address 103

set ip default next-hop 6.6.6.6


b) apply it to the inside (where the voice is connected to) interface:


int Ethernet0/0

ip policy route-map equal-access


s.nasheet Wed, 10/14/2009 - 12:28
User Badges:

Many thanks for the response.


Just want to confirm that using these acl line , if I mark all above UDP and TCP port , then all voice traffic will be catch by these ACL.


I am asking becasue in VOICE there are many other protocols. like SIP, TRP .


Thanks



virverma Wed, 10/14/2009 - 12:30
User Badges:
  • Silver, 250 points or more

all I can say, voice traffic works on ports,

so you can try mentioning different ports

virverma Wed, 10/14/2009 - 12:35
User Badges:
  • Silver, 250 points or more

Let me know as well if the other way works,

:)

Actions

This Discussion