10-13-2009 01:34 PM - edited 02-21-2020 03:43 AM
Hi, I'm trying to configure high available VPN, for studying purpose.
Here the topology I use:
http://bmigette.fr/wp-content/uploads/2009/10/slb_ha1.png
All the routers can ping each other.
I set this configuration on IAR1 and IAR2:
!
redundancy inter-device
scheme standby HSRPSYNC
!
!
redundancy
!
!
ipc zone default
association 1
no shutdown
protocol sctp
local-port 5000
local-ip 10.254.3.2
retransmit-timeout 300 10000
path-retransmit 10
assoc-retransmit 10
remote-port 5000
remote-ip 10.254.3.1
!
but nothing happens, even if I set debug ipc all, debug redundancy status and debug redundancy inter-chassis.
doing show ipc status give me 0 RX/Tx for all values
IAR2#sh redundancy inter-device
Redundancy inter-device state: RF_INTERDEV_STATE_PC_NO_HSRP
Scheme: Standby
Groupname: HSRPSYNC Group State: Init
Peer present: RF_INTERDEV_PEER_COMM
Security: Not configured
IAR2#sh standby bri
P indicates configured to preempt.
|
Interface Grp Prio P State Active Standby Virtual IP
Fa0/1 0 100 Active local 10.254.3.1 10.254.3.254
IAR2#
I use IOS 12.4-25b on a 7200 router
Any clues ?
Many thanks
10-13-2009 02:43 PM
I hope you don't have the exact same config on both, maybe you forgot to change :
local-ip 10.254.3.2
remote-ip 10.254.3.1
to
local-ip 10.254.3.1
remote-ip 10.254.3.2
on the other router ?
10-13-2009 03:20 PM
Yes, I parsed only one, but I set the correct IP addresses.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: