10-14-2009 04:21 AM - edited 02-21-2020 10:23 AM
hi,
I have Cisco ACS-1113. I want to connect this in existing network.
My query is ACS have two LAN interface. Whats the use of second interface as Cisco documents states "ACS SE supports the operation of either Ethernet connector, but not both connectors".
Thanks
Nilesh
Solved! Go to Solution.
10-15-2009 05:36 AM
It can communicate with other subnets just like any other device. If a device is not on the local subnet, it forwards to the default gateway and off it goes.
Here's a link to the configuration guide-
10-14-2009 05:53 AM
Currently two NICs are not supported, for example teaming the NICs. You can use either NIC, but only one of them, not both.
Hope that helps.
10-15-2009 12:28 AM
Hi ,
Thanks
Need more advice.
If there is only one NIC in use then how ACS do the communication between two different subnet.
I mean if have configure the Router/switch(which is supposed to manage) with 10.10.10.1/24 subnet & ACS IP as 20.20.20.0/24
I need to introduce ACS for the managing access to network device.
Can you please share the configuration document for the same.
Regards,
Nilesh
10-15-2009 05:36 AM
It can communicate with other subnets just like any other device. If a device is not on the local subnet, it forwards to the default gateway and off it goes.
Here's a link to the configuration guide-
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide