Unable to edit config in CLI

Unanswered Question
Oct 14th, 2009
User Badges:

After configuring a stand-alone 521AP, I am unable to get to configure mode. I can SSH, login and then get to enable mode. However, "configure" is not one of the available options. My list of available options are attached, as is my sanitised config.


Managing the AP though the WebUI works with no problems.


Stu



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Wed, 10/14/2009 - 05:29
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Stu,


The AP521 is part of the Cisco Mobility Express Solution :(


Q. Can the Cisco IOS command-line interface (CLI) be used to manage the Cisco Mobility Express Solution?


A. Because the objective of the Cisco SBCS was to create a simplified management system and interface for SMB customers, the CLI is limited to troubleshooting (SHO/DEBUG) commands only and cannot be used for configuration.


http://cisco.com/en/US/prod/collateral/wireless/ps7306/ps7319/ps7338/prod_qas0900aecd8060c860.html



Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics - Security & Network