Ringer Volume: Multiple DNs

Unanswered Question
Oct 15th, 2009
User Badges:

I know you can change it for the entire device by using the Volume +/- when the handset is on hook. I also see where you can configure this under the Line appearance for Ringer Setting (Phone Idle & Active) to Disable, Flash, etc.


Is it possible to selectively adjust ringer volume per line on one device that has multiple DNs assigned to it?


Thanks.

Craig L. Pollitt

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
testeven Thu, 10/15/2009 - 07:29
User Badges:
  • Cisco Employee,

Hi!


The ring volume/level is saved on the phone's memory, therefore it will apply to the device as a whole, not on a line basis.


HTH!


Regards,


Teresa.


If it helps, please rate.


Actions

This Discussion