Ref 1. : Configuring Frame Relay, http://www.cisco.com/en/US/docs/ios/12_2/wan/configuration/guide/wcffrely.html#Disabling_or_Reenabling_Frame_Relay_Inverse_ARP
Ref 2. : CCNA ICND2, Official Exam Certification Guide, Second Edition, ISBN 158720181X
Ref 3. : Frame Relay Question, http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.2cd2b0f5/17#selected_message
Is there any way on a router in a frame relay network to verify through an IOS command that Inverse-ARP has been disabled? Ref 2, the ICND2 book, on Page 500, second paragraph says, "The router disables Inverse ARP on a subinterface when the frame-relay map command is configured". There is no mention of this in the 12.2 command reference for 'frame-relay map' and 'frame-relay inverse-arp' commands. At Ref 3, the last post says that Inverse Arp needs to be manually disabled when statically mapping DLCI's to IP addresses. The topology being asked about seems to be point-to-point with subinterfaces. Ref 1, Frame Relay Question, doesn't mention anything about a disabled inverse arp either.
Your advice is appreciated.