Is it possible to have voice and data on separate vlans on spa 942 with firmware 6.1.5a

Unanswered Question
Oct 16th, 2009
User Badges:

Hi have tested the following and also different combinations but I cannot get the phone to work when I have 2 vlans


vlan 1=data

vlan2=voice


Phone configuration

Enable Vlans = no

CDP enable=yes

Enable PC Port VLAN Tagging:no

vlanid=1


on the switch I have the following

interface FastEthernet0/21
switchport multi vlan 1,2
switchport mode multi
switchport voice vlan 2
spanning-tree portfast


I can ping the pc attached to the phone on vlan 1 but cannot ping the phone which should be on vlan2.


I have tried all sorts of combinations of settings including setting the switch as a trunk but could not get the phone to work.

Can you pls indicate what I am doing wrong pls?


Regards

Chris Debono

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
marck_renton Mon, 10/19/2009 - 13:26
User Badges:

You can't ping the phone beacuase you have only one vlan on your phone. the correct configuration must be as follow in your phone:


Enable Vlans = yes

vlanid=2 (this is the vlan for the ip phone)

CDP enable=yes

Enable PC Port VLAN Tagging:no

pc port vlanid=1


I hope that it helps


Best regards.

Actions

This Discussion