10-19-2009 12:37 PM - edited 03-06-2019 08:11 AM
Hi All,
I am currently running cisco IOS and want to load fresh Cisco IOS. I connected the G1/2 into the TFTP server computer. The TFTP server interface is 10.0.0.2. I am unable to assign the ip address to the G1/2. how can I do the file tranfer from the computer to the switch bootflash and load the switch using the new image.
Thank you,
Siva
10-19-2009 12:49 PM
you need to make g1/2 a non switchport.
issue no switchport on the interface g1/2 and then assign an ip.
10-19-2009 01:24 PM
Thank you. I have done the tranfer of IOS image via VLAN1. I am unable to delete the VLAN information on the Switch. It is sandalone Switch. Not connected with any switch.
Cisco 4900 Switch.
Switch#dir cat4000_switch:
10-19-2009 01:29 PM
Issue a dir all command and find out where the vlan.dat is.
10-21-2009 04:23 AM
And be aware that VLAN1 cannot be deleted. It's the default VLAN.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: