cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
463
Views
0
Helpful
1
Replies

Inter-Cluster Trunk Failover

hugemongus
Level 4
Level 4

We currently have a non-gatekeeper controlled ICT between 2 campuses. One is running 5.1 and the other is on 7.1 - the ICT trunk is working perfect. The problem is that we do not have a failover to go out the PSTN when the WAN is down.

Cluster A dials #2XXXX (strips the #2 off and sends 4 digits). Cluster B dials #1XXXXX (strips off the #1 and sends 5 digits).

Both locations have an entire block of PSTN DIDs - the last 4 or 5 digits match the DN.

Suggestions??

1 Accepted Solution

Accepted Solutions

Jaime Valencia
Cisco Employee
Cisco Employee

Configure 2 route groups, 1 with ICT, 1 with PSTN GW

Assign them to a route list, ICT then PSTN

Configure the necessary transformations under route list config for the PSTN option to prefix the calls with the necessary digits to route them

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

1 Reply 1

Jaime Valencia
Cisco Employee
Cisco Employee

Configure 2 route groups, 1 with ICT, 1 with PSTN GW

Assign them to a route list, ICT then PSTN

Configure the necessary transformations under route list config for the PSTN option to prefix the calls with the necessary digits to route them

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: